Watch repairs:

Like all machinery, mechanical watches need regular servicing for optimum performance.

The following ten steps are undertaken by us during an overhaul:

1. Remove the movement from the case
2. Disassemble movement (up to 130 parts)
3. Visually check parts under microscope for wear and     rust, and replace faulty parts
4. Cleaning process – parts are immersed in a specially     formulated cleaning fluid to remove dirt, dust,
    sticky oil, etc. and then pass through two rinses
    cycles and finally through the drying chamber.
5. The movement is then reassembled, and oiled with     highest quality lubricants.
6. Case and strap are cleaned in ultrasonic machine.
7. Movement remounted into case.
8. New battery fitted where required.
9. Waterproof watches pressure-tested.
10.Time calibrated in workshop for 48 hours.

Other repairs undertaken include:

Battery Replacement, Clean Contacts, Water Pressure Test

Dial Repair, Glass Replacement, Strap/Clasp Repair, Case Restoration

Replace Stem & Crown, Hand Repair, Circuit/Module Replacement

Guideline to water resistant and water proof watches:

30m – resistant to accidental splashes – not suitable for showering or swimming

50m – suitable for showering or swimming but not diving

100m – suitable for swimming, snorkelling, water sports